| |
 |
|
|
| Introduction |
| |
Meicheng CP-255i Scaler Box
is designed to upscale digital/analog video signal from Composite,
S-Video, PC, Component (HD) and HDMI input sources, to digital
HDMI output of wide-range HDTV and PC resolutions, up to 1080p
and WUXGA (1920 x 1200.) Besides video upscaling, the scaler
box also converts digital/analog audio signal to digital format,
then output either through HDMI combining with the video,
or Coaxial S/PDIF separately. Meicheng CP-255I has a comprehensive
OSD menu that allows user to select a variety of output resolutions
and adjust for best picture quality. |
|
| Features |
| 1. |
HDMI 1.2, HDCP 1.1 and DVI 1.0 compliant |
| 2. |
Scales any PC (VGA ~ WUXGA)
/HD (480i ~ 1080p) resolutions to/from another PC/HD resolutions. |
| 3. |
Automatically detect the factory setting of the
connected display and output the corresponding resolution and
refresh rate, when the NATIVE output is selected. |
| 4. |
Supports 50/60Hz frame rate
conversion. |
| 5. |
Supports 3-D motion video adaptive, 3-D de-interlacing, and
3:2 / 2:2 pull-down detection and recovery. |
| 6. |
Provides output picture adjustment on contrast,
brightness, hue, saturation, sharpness, RGB (color tone) level,
and aspect ratio size. |
| 7. |
Supports high resolution input/output:
PC: VGA, SVGA, XGA, SXGA, UXGA, WXGA, WSXGA, WUXGA ,HDTV: 480i,
576i, 480p, 576p, 720p, 1080i, and 1080p |
| 8. |
Supports digital and analog audio input
and output. |
| |
|
|
|
| Package
Contents |
| 1. |
Meicheng CP-255I Scaler Box |
| 2. |
D-Sub (15pin) Cable |
| 3. |
3XRCA Cable (Composite Video
+ L/R Audio) |
| 4. |
Remote Controller |
| 5. |
5VDC Power Supply Adaptor |
| 6. |
Operation Manual |
|
| Operation
Controls and Functions |
| Front Panel
: |
|
| 1. |
POWER Button and LED Indicator: Press the button
to turn ON/OFF the power of the unit. The LED will illuminate
when the power is turned on. |
| 2. |
IR remote control sensor. |
| 3. |
Input Selection Buttons and LED Indicators: Press
each of the buttons (CV/SV/COMP/PC/HDMI) to select the desired
input source. The LED will illuminate when the corresponding
input is selected. |
| 4. |
MENU Button: Press the MENU
button to bring up OSD operation menu (see section“4.3 OSD Operation”
for reference.) |
5. |
+/- Buttons: |
| |
a. |
On the ?rst tier of OSD menu, use + and - buttons
to move up/down the highlight item for selection. |
| |
b. |
Once the desired option is selected, use + and - buttons to
toggle between setting values. |
| 6. |
ENTER Button: In OSD menu, use
the ENTER button to control the selection. |
|
|
| Rear Panel
: |
|
| |
|
 |
